Pioneer Multi Projection System RM-V1000NU Manual de usuario descargar pdf (Pagina 118)

117

APPENDIX (MVP manual)

*6 : Display of remote and manual states

REMOTE MODE : Remote state

MANUAL MODE : Manual state

*7 : Slot number

*8 : Type of input board

NTSC BOARD : NTSC input board

V.SCAN BOARD : Optional RGB input board

NO BOARD : No input board is incorporated

*9 : NTSC input board state

STANDARD MODE : When standard NTSC signal is input

NO STANDARD MODE : When non-standard NTSC signal is input

*10: Display of VBS/ Y/C select switch state

VBS : Composite video signal input (Indicates V FIL.ON for the V.SCAN BOARD)

Y/C : Y/C separation signal input (Indicates V FIL.OFF for the V.SCAN BOARD)

*11: Type of output board

4 OUT BOARD : 4 output board

NO BOARD : No output board is incorporated

To Perform NTSC Input Board Picture Quality Adjustment

To Set the Adjustment Mode [AJYB command]

To Exit the Adjustment Mode [AJN command]

Input: AJYB , AJN

Explanation: AJYB command : Sets the NTSC input board to the adjustment mode.

AJN command : Exists the adjustment mode.

• When adjusting the NTSC input board, the adjustment command will be ignored if AJYB is not executed.

• To set the optional RGB board to the adjustment mode, use the :A command. (Refer to pages 121 and on-

wards.)

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 158 159

Sin comentarios

Pioneer Multi Projection System RM-V1000NU Manual de usuario Pagina 118